TETRABETON

Vibrated pressed concrete construction materials

Classification, parameters, areas of application

Vibrated pressed concrete construction materials			Performance							Area of application
Type	Stre- ngth index	Options and types, scheme	Overall dimensions, cm			Other			Pres- sure strength Mpa
			B	H	L	V, dm3	V0, dm3	M, K6
1	2	3	4	5	6	7	8	9	10	11
Т.7,5	0		7,5	20	40	6	4,5	9,5	1,5	For vertical load non-bearing partitions
Т.10	0		10	20	40	8	5	11	1,5	For vertical load non-bearing partitions
	1								2,5	For type T.20 mixed masonry for facade walls, vertical load bearing
	2								10	Also, in case the facade wall is a washer to absorb seismic impacts
T.15			15	20	40	12	5,8	13	1,5	For non-bearing partitions with requirements for sound insulation
Т.20	0		20	20	40	16	8,9	20	1,5	For vertical load non-bearing interior and facade walls
	1								2,5	For vertical load bearing interior and facade walls
	2								10	Also, in case the facade walls are included to absorb seismic impacts
Т.25	0		25	20	40	20	9,8	22,5	1,5	For vertical load non-bearing interior and facade walls
	1								2,5	For vertical load bearing interior and facade walls
	2								10	Also, in case the facade walls are included to absorb seismic impacts
HS	0		20	15	50	15	7	15,5	1,0	Used as permanent formwork for flooring and roof reinforced structures to make a slab-beam section. To be laid on wooden scaffold
HG	0		20	16	52	16,6	7	15,5	1,0	Also HS application. To be laid on reinforced beams with preliminary set up armature for the secondary beams
К.15	0		15	20	40	12	6	14	1,0	To shape horizontal belts and beams, as well as to make solid formwork free collar beams
К.20	0		20	20	40	16	9,8	22	1,0	To shape horizontal belts and beams, as well as to make solid formwork free collar beams
К.20А	0		20	20	50	20	10	23	1,0	To shape horizontal belts and beams, as well as to make solid formwork free collar beams
Ш.20	0		20	20	50	20	6,5	15	1,0	For workform free implementation of disperse armoured reinforced washers

NOTE:

1. T10.6 and T20.6 have smooth shorts walls to shape even angles and holes. The said may be divided into halves within the loosen section by keeping the integrity of the halves to make tying up of the sections.
2. Vertical orientation is possible of the large T20.6 opening to make vertical belts.